20
WASHER INSTALLATION
1. Remove the washer installation hardware from the
plastic bag as shown in Picture 1.
2. Attach the rear brackets to the pedestal with four
#10 screws (2 per bracket) as shown in Picture 2.
3. Attach the front brackets and spacer plates to the
pedestal with four #10 screws (2 per bracket) as shown
in Picture 3 and 4.
SECTION B - Washer & Dryer 15”
Drawer
Pedestal
Installation
Instructions
IMPORTANT: Read and save these
instructions.
This kit is intended to be installed by
persons having electrical and
mechanical training and a level of
knowledge considered acceptable
in the appliance repair trade.
Your safety and the safety of others are very
important. Many important safety messages
are provided in these instructions and on
your appliance. Always read and obey all
safety messages.
WARN I NG
EXCESSIVE WEIGHT HAZARD
Two or more people may be required to move and
install the washer & dryer onto pedestals.
Failure to comply may cause back or other injury.
Tools needed:
level
9/16” open end wrench
#2 Phillips screwdriver
Washer/Dryer Installation Kit
2 – Spacer Plates (Washer)
2 - Rear Brackets (Washer)
14 - #10 x 1/2" Screws
(Washer / Dryer)
2 - Front Brackets
(Washer / Dryer)
2 - Rear Brackets (Dryer)
Picture 1
Do not remove this foam.
Picture 2
Picture 3
Spacer
Plate
Front
Bracket
