Electrolux 318202107, Service Manual

Page: 7 / 20

3
Section A - Installation Instructions
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
•
As a stand alone appliance
• As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front and the
surface must be capable of supporting 100 lbs (45 Kg).
Warm & Serve Drawer Dimensions
Stand Alone Installation
Combination Warm & Serve Drawer/
30" (76 cm) Built-in Oven Installation
NOTE: A 60" (152 cm) long cable is supplied with
the Warm & Serve Drawer.
A. HEIGHT B. WIDTH C. DEPTH
9 7/8 " (25 cm) 30" (76,2 cm) 24 5/8" (62,5 cm)
D. CUTOUT E. CUTOUT F. CUTOUT
HEIGHT WIDTH DEPTH
Min. 8 3/8" (21,3 cm) 28 1/2 " (72,4 cm) 24" (61 cm)
Max. 8 5/8" (21,9 cm) 28 3/4 " (73 cm)
D. CUTOUT E. CUTOUT F. CUTOUT G. HEIGHT
HEIGHT WIDTH DEPTH
Min. 8 3/8" (21,3 cm) 28 1/2 " (72,4 cm) 24" (61 cm) 1 1/2" (3,8 cm)
Max. 8 5/8" (21,9 cm) 28 3/4 " (73 cm)
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
H* =10 1/8" (25.7 cm) Min. is a Critical
dimension and has to be respected .
Depends on critical
dimension H
A. HEIGHT B. WIDTH C. DEPTH
40" (101,5 cm) 30" (76,2 cm) 24 5/8" (62,5 cm)
FLOOR
Warm and Serve
Cutout
Warm and Serve
Drawer
60" (152 cm)
Cord
Minimum distance to
floor 41/2" (11,4 cm)
Bottom of oven cutout
Caution : Two 3" wide X 3/4"
(1.9 cm) thick planks have to
be install and they should be
able to support 200 pounds.
(90.7 Kg)