6
Door Removal and Reversal Instructions
1.
Disconnect electrical supply.
2.
Remove toe grille (see page 4 to learn how).
To remove freezer door:
1.
Remove top hinge cover and screws.
2.
Trace around the hinge with a soft lead pencil. This makes reinstallation
easier.
3.
Remove top hinge and lift door off bottom hinge pin.
4.
Reverse this procedure to reinstall freezer door.
To remove refrigerator door:
1.
Place wood block under door to support its weight.
2.
Detach the multi-wire cable connector located below the door.
Grasp both sides of the connector firmly and pull apart.
3.
Detach the water tube from the connector located below the door. The
connector releases when you press its outer sleeve inward.
NOTE
: If refrigerator has been used, have a container ready to catch
excess water from tube.
4.
Remove the bottom hinge screws and hinge, holding the door as its
weight rests on the wood block.
5.
Lay the door on its side to avoid damage to the water tube and cable.
6.
Remove the center hinge screws and hinge. Ensure plastic washer
stays on hinge pin.
7.
Reverse this procedure to reinstall refrigerator door.
When both doors have been reinstalled, connect water line by inserting tube
and pushing until mark touches face of fitting. Connect cable, replace toe grille,
and plug in electrical power cord.
DOOR REMOVAL INSTRUCTIONS:
If your refrigerator will not fit through an entrance area, you can reduce its size
by removing the doors. Check first by measuring the entrance.
IMPORTANT:
Before you begin, turn the refrigerator temperature control
to “0” and remove the electrical power cord from the wall outlet. Remove
any food from door shelves.
Top Hinge
Cover
Top Hinge
Center
Hinge
Shim
Pin
Bottom
Hinge
Water Tube
Cable
Wood Block
