Electrolux 236200 Installation And Operation Instructions Manual Download Page 5

Page: 5 / 24

5958 962 00

5954 00U 01

2. POSITIONING

• Unpack the appliance, carefully remove the protective

lm from

outside panels, making sure no traces of glue remain. If necessary,

remove them using a suitable solvent.

Remove the packing using protective gloves.

Lift the appliance with a lift truck, remove the base, and position

it the place of use.

Remove the protective

lm and make sure the packing material

is not dispersed in the environment but disposed of according to

the current regulations in the country where the product is used.

6-10 GN

20 GN

5 1 ” 130 mm

4 23 ” 120 mm

11 7 ” 300 mm

6-10 GN

20 GN

6-10 GN

20 GN

• For disposal of the packing, see the section "The Environment"

• For the overall space required and connection dimensions,

refer to the installation diagrams given on the

rst pages of this

instruction handbook.
• The left side of the appliance must remain at least

from

other surfaces to enable maintenance operations, whereas the

right side and back must remain

10 cm

from any surface.

• Position the appliance on a

at surface and, if necessary, adjust

the height of the worktop by means of the adjustable feet.
• The appliance is not suitable for built-in installation.

Attention:
Make sure the steam coming from the oven di-
scharge or adjacent appliances does not reach
the aeration vents (for cooling internal compo-
nents), located at the bottom of the appliance.

3. ELECTRICAL CONNECTION

• Connection to the electrical power supply must be done in
compliance with the current national and local regulations.

•  Before connecting, make sure the voltage and frequency match
that given on the dataplate.
• The appliance must be connected to the power supply in a
permanent way. Connection must be made with an H05 RN-F
type cable. The power cable must be installed in a metal or rigid
plastic pipe without any sharp parts.
•  An omnipolar switch of suitable capacity with contact opening
distance of at least 3 mm must be installed ahead of the appliance.
This switch must be installed in the building's permanent electrical
system, in the immediate vicinity of the appliance.
•  A device (interlocked plug, lockable switch or similar devices)
lockable in the open position during maintenance must be installed
ahead of the appliance.

• Appliance max. leakage current is 5 mA.
• The appliance must be connected to an effi cient earthing system.
For that purpose, the connection terminal block

has a terminal with the symbol

for connecting the earth wire.

The appliance must also be included in an equipotential system.
This connection is made with the setscrew marked

, located

externally near the power cable entry.
The equipotential wire must have a section of at least 10 mm

3.1 POWER CABLE INSTALLATION

To connect the power cable to the appliance, proceed as follows:

Model 6 - 10 - 20 GN

• Remove the left side panel.
• Connect the cable to the terminal block as shown in the wiring
diagram attached to the appliance, and secure it with the special
cable gland.

The manufacturer declines any liability if the current national
and local regulations and possible safety regulations are
not respected.

4. WATER CONNECTION

(See the installation diagrams at the beginning of this handbook)

When connecting the appliance to the water system with
hoses they must be new and not used.

The oven has two separate water supply inlets ("

" and "

").

C -

Water drain manifold

B - Injection water supply connection
N -

Condensate and Cleaning water connection

I -