33
Installation
Positioning
Place the refrigerator away from direct sunlight and
heat sources.
Maintain recommended ventilation - see Fig. 1.
Make sure the refrigerator is accurately levelled turning
the adjustable feet in order to avoid vibrations and noi-
ses.
This is a built in design to be aligned with other furnitu-
re
Cleaning the interior
Do not use alcohol or any cleanig product containing
alcohol because it can damage the cabinet.
Before using the appliance for the first time wash the
interior whith luke warm water and some neutral soap
so as to remove the typical smell of a brand-new pro-
duct arid then dry thoroughly.
Do not use detergents or abrasive powders as these
will damage the finish.
Remove security used for transportation.
Electrical connection
m
Before plugging the appliance make sure that the vol-
tage and frequency shown on the «Technical
Features» correspond to your home supply.
m
It is essential that the appliance be efficiently eart-
hed.
For this purpose the supply cable plug incorporates a
special earth contact. If the sockets of your domestic
wiring system are not grounded, have the appliance
connected to a separate ground wire in accordance
with existing safety regulations.
«THE MANUFACTURER DECLINES TO ACCEPT
ANY LIABILITY IF THIS SAFETY RULE IS NOT
OBSERVED».
m
Should a change of the supply cord be necessary,
remove the lid of the terminal board acting on «E» and
«F» as shown figure 3 in order to gain access to
the terminals. Fig. 3.
Starting up
Plug the appliance into the mains.
Make sure the inner light «H» turns on when
opening the door.
Turn to intermediate position the knobs of the
«temperature regulators» «h» for refrigerating
compartment and «f» for freezing compartment.
Fig. 3
Fig. 2
Fig. 1