Electrolux Professional IB42310, Installation Manual

Page: 17 / 24

Installation manual
17
11 Disconnecting the machine
Important
If you wish to disconnect the electrical supply cable, it is more wise to do it once the machine id cooled down and
to stop the ironer with the bed contact with the cylinder.
Proceed as follows:
• When the bed is cold, move it against the cylinder by
pressing on the control pedal and activate the On/Off
switch to stop the electrical supply.
• Stop the electrical supply by the main switch.
• You can now disconnect the electrical supply cable.
• To reconnect the machine, it is imperative to check
the order of connection of the phases before starting
the ironer (see previous page).
12 Releasing process to follow in case of connection while the bed is in back
position
If you connect the machine with the bed in back position and the control pedal activated (when two wires of phases
are inverted), an electrical device doubled with a mechanical system of locking prevents to deteriorate essential
mechanism organs.
1. Stop the machine’s electrical supply by the main switch.
2. Invert two wires of phase (see previous page).
3. Remove the right lateral casing.
4. Unscrew the screw (A)
while holding the bed , this last comes automatically in position against the cylinder.
5. Block the screw again (A) and reassemble the lateral casing.