14
A supply line with insufficient flow will affect correct
operation of the appliances connected to it.
For detailed information about gas connections and all
the appliances regulations, see the complete Installa-
tion and User manual plus appendix, on the web site.
E.2
Electrical connection
Before connecting the appliance to the power supply
1. Make sure the voltage and frequency match that given on
the dataplate.
2. Connect the appliance in a permanent way with an H07
RN-F type cable.
3. Install the power cable in a metal or rigid plastic pipe
without any sharp parts.
4. Arrange a suitable high-sensitivity manual-reset differ-
ential omnipolar thermal-magnetic switch with contact gap
enabling complete disconnection in category III overvolt-
age conditions.
Install the switch in the building's electrical system, in the
immediate vicinity of the appliance.
5. Verify that a safety circuit breaker is installed between the
power cable of the appliance and the mains electric line.
The contact opening max. distance and leakage current
must comply with the local safety regulations.
6. Install ahead of the appliance a device (interlocked plug,
lockable switch or similar devices) lockable in the open
position during maintenance.
7. Connect the appliance to an efficient earthing system.
For that purpose, the connection terminal block has a
terminal with the symbol
for connecting the earth wire.
8. Include also the appliance into an equipotential system.
This connection is made with the setscrew marked
,
located externally near the power cable entry.
For detailed information about the power cable instal-
lation see the complete Installation and User manual
on the web site.
F
PRODUCT DESCRIPTION
F.1
Introduction
• The appliance is intended for industrial use by trained
personnel.
• Do not use the appliance empty or in conditions that
compromise its optimum efficiency
Also, if possible, preheat the appliance immediately before
use.
• This appliance is designed for cooking food. Any other use
is improper.
CAUTION
The machine is not suitable for installation
outdoors and/or in places exposed to
atmospheric agents (rain, direct sunlight,
etc.).
F.2
Appliances overview
Gas models
Cooktop — Fig. 1
Cooktop with igniter without
pilot flame — Fig. 2
The gas control knob “H“ of each burner has following symbols
(see Fig. 1 or Fig. 2):
“Off“
“Pilot ignition“
“Max flame“
“Min. flame“
The igniter button “L“ (if present) has following symbol (see Fig.
2):
“Lightnin On“
Gas models
Oven — Fig. 3
Fan oven — Fig. 4
The thermostatic valve control knob “I“ has following symbols
(see Fig. 3 or Fig. 4):
“Off“
“Pilot ignition“
“On“
The adjusting knob “L“ select the required temperature and
has the following positions (see Fig. 3 or Fig. 4):
100:
“Minimum temperature“
110...250:
“Medium temperatures with positions range
between 110
℃
and 250
℃
“
270:
“Maximum temperature“
The button “P“ activate fan oven.
Electrical models
Cooktop — Fig. 5
Oven — Fig. 6
H
H
L
I
L
I
L
P
B
A
E
D
G
A
