Electroconcept SCANNER 30, Instruction Manual

Page: 3 / 9

1. Safety instructions
Please carefully read these instructions as they include
valuable information for installation, operation and
maintenance of this device .
Warning

Keep this manual for future consultations. If you resell your scanner to an other individual,
make sure to also give him this manual.
 Unpack and carefully check that the scanner didn’t take any damages during the transport
before using it.

Before any connection, make sure that both the voltage and the frequency of your power
source match your scanner specifications.

Check your device as well as your equipment’s grounding.

This device is only meant for indoor use ; protect it from heat and humidity (allowed
ambient temperature from 10 to 40°C).

The scanner must be set up in a ventilated area, at least 50cm away from any adjacent
surface. Check that no ventilation hole is blocked.

Unplug the scanner’s power source before any maintenance or handling operation.

Only replace the fuse by a fuse of the same type.

In order to avoid any fire hazard, check for any flammable source nearby.

Use safety cables to secure the scanner. Take into account the weight of the scanner upon
positioning it on a high up structure in order to avoid the fall of the structure and thus
risks of injury.

Switch off the power and let the scanner cool down for about 15 minutes before transport,
for the scanner’s surface may be hot still.

In the event of a serious functioning problem, stop immediately to use the device. Do no
ever try to repair the device by yourself. Repairs made by unqualified individuals may
cause damages or malfunctions. Contact the nearest approved technical support center.
Always use spare parts of the same type.

Do no connect the scanner to any dimmer or power pack.
 Do no open the device during its operation, the high voltage may cause a lethal electrical
shock.

In order to prevent or reduce risks of electrical shock or fire, do not expose the device to
rain or humidity.

Do not ever touch the led with your bare fingers after use to avoid serious injuries, for the
led may be very hot still.

Do not start the scanner without led to avoid degradation of the box..
3