TECHNICAL SPECIFICATIONS
:
Power supply
：
AC230V ±10
％
Frequency
：
50Hz
～
60Hz±10
％
Power consumption
：
max 100W
Laser power specification : RGB 3000mW (~800mW Green, ~1000mW Red ,
~1500mW Blue)
Wave length : 520nm (Green)/638nm(Red)/450nm(Blue)
Laser class : Class 4
Canaux DMX
：
14
Control signal
：
DMX-512 signal
Scanner :25K et 30K à 8°
Control mode : DMX-512, Stand-Alone, ,Sound to Music,ILDA
、
master and slave
Environment : Indoor use only
General safety instructions and warning notices
This laser is a CLASS IV laser product .
This product has to be operated by trained laser operator.
Avoid eye or skin exposure to direct or scattered radiation.
Never look directly into a laser beam or directly into laser aperture when the laser projector is on.
Always stay focused during lasers operating in order to stop the laser projector if anything goes
wrong.
The user/owner is fully responsible for any damages caused by the laser projector, use it in
accordance with applicable laws in your country especially safety regulations laws and any
certification bodies.
Installation notice :
Before any use check that the product do not suffer during transport.
While installing the device, do not plug the power supply cord.
Do not use the laser projector outside, indoor use only.
Do not switch on the laser projector as soon as installed, wait for the laser projector to be at the
same temperature of the room to avoid condensation/moisture/mist to damage the product.
When rigging use safety cords able to resists ten times the weigh of the laser projector.
Rig the laser projector at least 50 cm away from any wall or flammable objects.
Do not cover the laser projector and place it away from heat sources like spotlights to ensure a
good air flow around the product.
At least laser beams should not hit anything under 3 meters from the floor level. Be attentive to
reflective surfaces.
The laser projector has to be easily stopped if necessary, ensure the power cord or circuit breaker
is accessible at anytime during the laser show. Do not use dimmers or electronic switch to power .
Refer to local laws for further instructions when operating the laser projector.
Warning : ! All connections have to be made with the laser projector switched off !
2
