background image

TL880P

Very-Low-Frequency

Powered Speaker

System

Digital  Capable(TM) designed expressly to meet

the dynamic and low-frequency potential of
digital sound on film
THX approved’

Side-mounted connection panel facilitates
hookup when depth behind the screen is

restricted

Two EVX-180A 18-inch woofers, rated at 2,000
watts of combined continuous program power,

provide very high low-irequency pumping ability

to 

below 23 Hz

Unusually exlended 

LF response also appropriate

for very-low-frequency synthesized effects,  down-
tuned bass guitars or pipe organ
Internal, P1250 power amp delivers 1,200  watts
continuous to the loudspeakers

On-board P1250 processing provides “step-down”
ED, limiting to prevent amp clipping under high-
output conditions, and infrasonic speaker
protection

‘THX is a registered trademark of Lucasfilm Ltd.

Description and Applications

The Electro-Voice TL880P  is a member of

the TL series of low-frequency enclosures.

The TL880P is a powered subwoofer de-

signed expressly for digital sound on film

and other applications which require very

high low-frequency pumping ability ex-

tending to 25 Hz and below. The TL880P

features an Electra-Voice P1250  power am-

plifier, set up in bridge mode driving two

EVX-180A 457-mm

 (1

 8-in.) speakers, with

a combined rating of 2,000 watts continu-

ous program, connected in parallel. The

P1250  can deliver 1.200 watts continuous

(20-20,000  Hz) to the resultant 4-ohm load.

The P1250  has on-board signal processing

which supplies:

1. Low-frequency equalization nec-

essary for “step-down” operation

of the loudspeaker system, pro-

viding an overall system response

whose 3-dB-down  point 

 is 23 Hz.

2 .   I n f r a s o n i c   p r o t e c t i o n   o f   t h e

EVX- 180A-s below the P1250’s

peak boost frequency of 26 Hz.

3. Output limiting that prevents ampli-

fier clipping under high-output con-

ditions.

The side-mounted input for the amplifier

facilitates behind-the-screen installation,

where limited space between the screen and

theatre wall often makes it difficult to con-

nect to the back of an enclosure.

Directivity

In addition to motion-picture applications, the

TL880P is highly appropriate as the subwoofer

in large, multiway systems for contemporary

music playback and sound reinforcement. The

TL88OP  has more output below 40 Hz than the

devices typically used in these applications, in

either the normal (25 Hz) or alternative

(30 Hz) box tuning (see Alternative Vent Tun-

ing and Equalization Options section). Thus.

the TL880P  is not only appropriate for the

more typical 40-Hz-and-above subwoofer re-

quirements, but also for those applications,

e.g., very-low-frequency synthesized effects

and down-tuned bass guitars, that require high

output below 40 Hz. This extended low-fre-

quency performance also plumbs the depths

of the symphony orchestra and pipe organ.

The directional characteristics of the TL88OP

were measured in Electro-Voice’s large

anechoic chamber; the test signal was one-

third-octave filtered pink noise at the fre-

quencies indicated. A full spherical measure-

ment system was used. All directional informa-

tion was measured at 6.10 meters (20 feet).

Figure 2 illustrates the horizontal and verti-

cal polar responses. Figure 3 shows the hori-

zontal and vertical beamwidths. Beamwidth

is the angle at which the horizontal and ver-

tical polar responses have decreased in level

by 6 dB when compared to the axial fre-

quency response.

Figure 4 illustrates the total directivity of the

TL880P The directivity factor R,(Q) is the

ratio of the SPL of the TL880P  at a given

point to the SPL of an ideal omnidirectional

source at that same point. The directivity

index, 

 is calculated by   = 10 log,,, R,.

Frequency Response

Power Handling

The TL88OP’s  axial frequency response was

measured in Electro-Voice’s large anechoic  cham-

ber at a distance of 3.05 meters (10 feet) with a

swept sine-wave input. Figure 1   has been aver-

aged and corrected for 1 watt/l meter into the

transducers.

Electro-Voice 

components and systems are

manufactured to exacting standards, ensur-

ing they will hold up, not only through the

most rigorous of power tests, but also

Summary of Contents for TL880P







Reviews: