-
4
-
English
Handheld Transmitter Setup
and Operation
1. Insert Battery.
Remove the battery compartment
cover by unscrewing it completely. Insert a 9V
battery, terminal end first into the battery
compartment.
NOTE:
The HTU-2 unique design allows the
battery to be inserted and used regardless of
the positive and negative terminal position.
2. With battery compartment still open,
turn the
unit so you can see the display and the control
panel. Turn the unit on by sliding the power
switch forward to the on position. The battery low
LED will light for a second and the display will
show the Group and Channel numbers.
3. Change the group and channel numbers
to
match those displayed on the receiver by pressing
SET. The Group number will flash and can be
changed with the UP/DOWN keys. Once the
desired group number is showing, press SET to
select and the Channel number will flash. Select
the Channel and press SET again. The flashing
will stop and the channel is now set.
4. Other Screens:
Press SET and DOWN at the
same time to display the battery level. Press SET
and DOWN again to display frequency. Press
them one more time to return to Group and
Channel.
5. Frequency Edit Mode -
Press SET from the
frequency display screen to enter frequency edit
mode. Press the Up and Down to adjust frequency
in 25 kHz increments. Holding the Up or Down
buttons down will auto step the frequency; slowly
at first, then quickly. You can also enter frequency
edit mode by pressing SET and UP at the same
time from either the Group and Channel or
Battery status display screens. Pressing SET and
UP at the same time from the Frequency display
screen will enter Group and Channel edit mode.
6. Power Lock Out -
Press SET, UP, and DOWN at
the same time and hold 3 seconds to lock the
power switch on. To turn the unit off, place the
power switch in the OFF position and push SET,
UP, or DOWN. To remove the lock, press SET,
UP, and DOWN again at the same time and hold 3
seconds. A one-time only ON-LOCK mode can
also be entered by quickly cycling the power
switch three times.
7. Set Key Lock-Out,
by pressing and holding the
UP and DOWN arrow keys together for 3
seconds, the SET key is disabled. To reactivate the
SET key simply press and hold the UP and
DOWN keys again for 3 seconds.
8. Verify reception.
With the transmitter and
receiver on and matching Group and Channel, the
main receiver display should be indicating an RF
signal on the bar graph. Speak into the
microphone and the Audio Meter bar graph should
indicate audio signal presence. If the level meters
do not show reception, make sure the channels are
matching and refer to the troubleshooting section.
HTU-2 Controls,
Connectors, and Indicators
1.
Main Display - LCD
(Channel, Frequency or Battery Level Indication)
2.
Battery Low LED - Lights when battery is low
3.
Power On/Off Switch
4.
Set Switch
5.
Channel/Frequency Up Switch
6.
Channel/Frequency Down Switch
7.
Microphone Gain
8.
9V Battery Holder
9.
Battery Cover - Screw type.
Handheld Tr a n s m i t t e r H T U - 2
Figure 3 Handheld Transmitter
Figure 4 Transmitter
Summary of Contents for Telex RE-2
Page 2: ......
