Electro-Voice Telex RE-2, Operating Instructions Manual

Page: 5 / 60

NOTE: Groups 9 and above are set up to work
with the other US frequency band (A and B). If
you are using a mix of Band A and Band B, scroll
down to these groups and use the clearest group.
6. Change Lock-Out:
By pressing and holding the
UP and DOWN arrow keys together for 3 seconds,
the SET key is disabled. To reactivate the SET
key, simply press and hold the UP and DOWN
keys again for 3 seconds. This feature can be
useful when the receiver is in a location where
unauthorized personnel have access to the
receiver.
7.
For set up, make sure the mixer or amplifier input
used for the RE-2 is muted or turned down to a
minimum level.
8.
Plug an audio cable (not supplied) into the 3 pin
XLR or 1/4 inch output of the RE-2.
a. NOTE:
The XLR connector is the preferred
connection since the output is balanced and will be
more immune to noise for longer runs of cable
although either can be used with good results. If
the 1/4 inch connector is used, adjust the output
level on the back panel to 12 o'clock (midway in
the range) to start and adjust later if necessary.
Now refer ahead to transmitter setup and return
to step 9 when that is completed.
9.
With the transmitter on, speak into the microphone
or play the guitar. Turn up the level on the mixer
or amplifier until you are able to hear the desired
signal. If no audio is present, repeat setup and
refer to the troubleshooting section.
NOTE:
If the 1/4 inch output is used, it may be
necessary to adjust the receiver output until the
volume level from the wireless system
approximates the level of an equivalent wired
microphone/instrument.
10. Squelch Adjustment
- The squelch setting can
be used to maximize range or immunity to noise.
Press and hold Up for 3 seconds. The current
squelch setting will be displayed. Adjust the
squelch using the UP/DOWN keys. Maximum
squelch (9) maximizes noise immunity but
limits the range. Minimum squelch (1) will
maximize the range but allow more noise to
break through the squelch. Press SET to save
the new squelch setting.
-
3
-
English
Display Status Button Function Activated Edit Accept
Nothing Flashing Press and hold SET Auto ClearScan n/a n/a
Nothing Flashing SET Edit Group – Group will Flash SET
Group flashing Press and hold SET ClearScan Group –
list clear groups in order SET
Group flashing SET Edit Channel - Channel will Flash SET
Channel Flashing Press and hold SET ClearScan Channel – list clear
channels in order SET
Nothing flashing Press and hold UP Edit Squelch Setting SET
Nothing flashing Press and hold Edit Lock n/a n/a
UP & DOWN – SECURE will appear
Edit Lock On Press and hold
UP & DOWN Return to access mode n/a n/a
Power Off Press and hold SET Toggle between Guitar
and Voice mode
n/a n/a
Nothing flashing Press SET und UP Toggle to frequency Mode
– Freq. will flash
SET
Frequency Flashing Press and hold SET ClearScan Band -
ClearScan will flash
n/a SET
ClearScan Band Press SET End ClearScan Band after
Running next full Scan n/a n/a
ClearScan Band
Results
n/a Clearest frequencies listed SET
Frequency Mode Press SET und UP Return to Group and
Channel Mode
n/a n/a
Nothing flashing Press and hold DOWN Display Software Revision n/a n/a
Receiver Push-Button Reference Sheet