U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497 Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0 Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051 Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/553-5992 or 402/467-5321
For technical assistance, contact Technical Support at: 800/392-3497 or 952/736-4656
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 6/2006
Part Number 38110-216 Rev. E
Architectural & Engineering Specs:
Frequency Response:
Polars:
PolarChoice™ PC Plus-5, PC Plus-12, PC Plus-18
The microphone shall be a back-electret condenser type with a frequency response of 50 Hz to 20 kHz. The microphone shall have a
nominal, balanced output impedance of 200 ohms. The microphone shall have four selectable polar patterns: omnidirectional, cardioid,
supercardioid, and hypercardioid. The microphone shall have an output level of 5.6 mV/Pascal, and outputs shall not be appreciably affected
by the following temperature and humidity extremes: -29° to 74° C (-20° to 165°F) when the relative humidity is 0-50%; -29° to 57°C (-20° to
135°F) when the relative humidity is 0-95%. Dimensions shall be 187 mm (7.35 in.) long (PC Plus-5), 363 mm (14.3 in.) long (PC Plus-12), and
516 mm (20.3 in.) long, (PC Plus-18) with a maximum head diameter of 14.6 mm (0.58 in). The PC Plus-5 microphone shall include a 127 mm (5
in.) gooseneck. The PC Plus-12 microphone shall include a 305 mm (12 in.) gooseneck. The PC Plus-18 microphone shall include a 457 mm
(18 in.) gooseneck. The gooseneck will be attached to a miniature base that has a top mounted push-button, and a status LED that lights
when audio is active. The push-button will be configurable for push on/off, or push-to-mute operation. Furthermore, when the push-button is
set for push on/off operation, the status of the microphone when power is initially applied, will be configurable. The miniature base will have
an integral 3-pin XLR connector. The lower section housing of the miniature base will be removable to facilitate flush mounting of the
microphone on a flat surface and appropriate hardware will be supplied for this purpose. The microphone will have a switchable high pass
filter to roll off low frequencies. All controls except for the push button will be only accessible from the bottom of the microphone base. The
microphone shall be of metal construction. The microphone will include and external windscreen. The microphone shall have a nonreflecting
black finish. The Electro-Voice PolarChoice™ PC Plus-5, PC Plus-12, or PC Plus-18 is specified.
