Electro-Air EA-15000, Installation Manual

Page: 5 / 10

Electroair Acquisition Corp. IM EA-15000 Page 5 of 10
Revision 01 Prepared by: EAC 02/04/2020
Precautionary Statements:

ALWAYS STAY OUT OF THE PROPELLER ARC!

CAUTION: Disconnect the battery before starting this procedure.

CAUTION: Prior to any drilling or cutting, verify that there is proper clearance.

CAUTION: Do not cut or alter any structural tubing, aluminum panels, or skin.

CAUTION: Follow these instructions very carefully to insure a correct hook-up of
the Ignition/Starter Switch Panel. Skipping ahead or taking short cuts increases
the risk of an incorrect installation and either a poor performing EIS or the
possibility of damaging equipment. Prior to turning on bus power, verify the
wiring. Please call Electroair with any questions (
sales@electroair.net or 248-
674-3433).

CAUTION: Do not secure any radio communication, navigation, transponders or
intercom wiring to any ignition related wires, boxes, or sensors. Doing so will
cause poor to noisy transmission or reception of com and intercom and/or poor
or no navigation function. Keep at least 3 inches between these wires.

CAUTION: If using a non-impulse coupled magneto aka direct
drive magneto aka non-starting magneto, update pilot checklist/
POH to have MAG switch in OFF position during starting.

Consult with appropriate licensed mechanic.

Consult applicable service manuals for the aircraft.