background image

2

EN

traNSmittEr iNStructioN maNual

TransmiTTer ConTrols

PoWEr SWitch

rEvErSE SWitch

throttlE trim

StEEriNg trim

StEEriNg WhEEl

aNtENNa        

Pull antenna out to its 

full length for best results 

(ECX1067 Antenna Only)

Adjusts the neutral point of 

the electronic speed control

Adjust top make the vehicle 
drive  straight  with  no  input 

at the steering wheel

Control steering. Right and 

Left steering with ST. REV 

Switch on N (See ST. REV 

switch)

Allows you to change the 

direction of steering  (ST. REV) 

and throttle (TH. REV) controls. 

(Default settings are “N”)

Power on 

or off the 

transmitter

BattEry lEvEl iNdicator

Note: Red light will flash with an 

audible signal (beep) when batteries 

are low

Good battery power

Low battery power

throttlE triggEr

Controls  power  to 

motor  for    forward 

or  reverse  (See  TH. 

REV switch)

Stop

Reverse 

(when TH. 

REV switch 

on N)

Forward    

(when TH. REV 

switch on N)

St. d/r

Adjusts the amount the front wheels 

move when turned left or right

(Steering Dual Rate) 

chargEr Port

Read instructions before charging. 

Charge only rechargeable batter

-

ies. Non-rechargeable batteries 

may burst causing injury to persons 

and/or damage to property. 

Note: The center pin on the charge jack is positive

.

am 27 mhz traNSmittEr cryStal

AM Transmitter Crystal 

(RX)

AM Receiver Crystal 

(RX)

Note:  Paired  AM  crystals  must  be 

replaced to change control frequencies. 

Do NOT use FM Crystals.

Part #

Description

ECX1081 Crystal Set 1 26.995
ECX1082 Crystal Set 2 27.045
ECX1083 Crystal Set 3 27.095
ECX1084 Crystal Set 4 27.145
ECX1085 Crystal Set 5 27.195
ECX1086 Crystal Set 6 27.255

insTalling TransmiTTer BaTTeries

1. Slide panel open on

bottom of transmitter.  

2. Obey battery plus (+) and 

minus (-) diagram in transmitter 

to install eight (8) AA batteries.  

3. Slide panel closed 

on  transmitter.  

Note: Alkaline AA size batteries are recommended. 
Note: Optional AA NiMh battery charger DYN1970 is available. Use only batteries approved for use with that charger. DYN1970 2300mAh Tx NiMH Conversion Kit:FUT, ECX

ALWAYS use fully charged batteries in the transmitter. 

Low battery power can result in loss of control of the 

R/C vehicle. 

NEVER  install  damaged  batteries,  batteries  of  mixed 

types or batteries of different ages in the transmitter.  

Remove exhausted batteries.

NEVER store transmitter with batteries installed. 

Summary of Contents for Circuit 1/10 Electric Stadium Truck

Page 1: ...usly touching them Do not put fingers or any objects inside rotating and moving parts as this may cause damage or serious injury Be sure that your operating frequency is clear before turning on or running your model and never share the same frequency with somebody else at the same time Ensure that others are aware of the operating frequency you are using and when you are using it Always turn on yo...

Page 2: ...e batter ies Non rechargeable batteries may burst causing injury to persons and or damage to property Note The center pin on the charge jack is positive AM 27 MHz Transmitter Crystal AM Transmitter Crystal RX AM Receiver Crystal RX Note Paired AM crystals must be replacedtochangecontrolfrequencies Do NOT use FM Crystals Part Description ECX1081 Crystal Set 1 26 995 ECX1082 Crystal Set 2 27 045 ECX...

Page 3: ... Product needs to be inspected or repaired please use the Horizon Online Repair Request submission process found on our website or call Horizon to obtain a Return Merchandise Authorization RMA number Pack the Product securely using a shipping carton Please note that original boxes may be included but are not designed to withstand the rigors of shipping without additional protection Ship via a carr...

Page 4: ... Normen Harmonised standards applied EN 60950 Gesundheit und Sicherheit Health and safety requirments EN 301 489 1 Schutzanforderungen in Bezug auf elektromagnetische Verträglichkeit EN 301 489 3 Protection requirement concerning electromagnetic compatibility EN 300 220 Elektromagnetische Verträglichkeit und Funkspektrumangelegenheiten ERM Technical requirements for Radio equipment Elmshorn 05 05 ...

Reviews: