Page
8
of
15
INSTALLATION OF WINDOW KIT
1.
Partially open the window and then fix the slide bare into the opening in the window, by
putting it into position before closing the window onto it to seal the gap.
2.
Push the fishtail adaptor into the slot in the slide bar
Note:
The slide bar is only designed to be installed with sliding or sash windows or doors.
The slidebar is not designed or to be used with any other style of window. However
the fish tail adaptor can be used with most windows / doors. When using the
cooling mode ensure that the opening is left as small as possible.
The best form of installation is through a wall duct.
By properly venting you expel hot air from your room while efficiently cooling it.
Important safeguards
The length of the soft hose extends from 28 cm to 150 cm. If hose is
extended above this length the unit may malfunction and this can
invalidate the warranty.
The outlet vent must be well ventilated and not obstructed as this will
cause the unit to overheat.
Avoid bending the air hose more than 30 degrees.
