11
REPLACING THE BULB
1.
Switch off the extractor hood and
ensure it is also switched off at
the mains supply.
2.
Remove the grease filter.
3.
Unclip the lamp holder using the
spring clip on the rear of the holder.
4.
Disconnect the wiring
connector on the lead
running to the lamp holder.
5.
Replace the holder and lamp
with identical unit available
from the
retailer/manufacturer.
6.
Remember to switch on at the mains once installation is
completed and the hood has been fully reassembled.
Information
Clean ventilation fans frequently. Grease should not be allowed to
accumulate on fan or filter.
Note:
The filter is available from the same retailer as
the hood under reference eiqgf5712.
eiqvissteel60
takes grease filter eiqgf7048
INSTALLING THE OPTIONAL CARBON FILTER:
1.
Remove the grease filter
2.
The carbon filter is located at
the end of the motor. To fit,
rotate the filter clockwise onto
the motor housing; to remove,
rotate filter anti-clockwise until
it is unscrewed.
Warning
: the carbon filter cannot be washed or recycled. It should
be replaced after approximately 2-3 months of use.
Note:
The optional carbon filter is available from the
same retailer as the hood under reference eiqc3846.
