15
LIGHT REPLACEMENT
Important:
The light fitting must be replaced by the manufacturer, its service agent or
similarly qualified persons.
Always switch off the electricity supply before carrying out any operations on
the appliance. When handling the light fitting, make sure it has completely
cooled down before any direct contact to hands.
• Switch the unit off and disconnect the power.
• Wait until the light fitting has cooled down before replacement.
• Pull out the LED light carefully with a screwdriver and replace with
the same type and rated LED light (2*2W LED light)
• Replace the front part back to the fitting with screwdriver.
• ILCOS D code for this lamp is: DBR-2/65-H-64
– LED modules, self- ballasted – round lamp
– Max wattage: 2 W
– Voltage range: AC 220-240V
– Dimensions:
TROUBLESHOOTING
Fault
Cause
Solution
Light on, but fan does
not work
The fan blade is jammed.
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
The motor is damaged.
Both light and fan do
not work
Light bulb blown
Replace the bulb with correct
rating.
Power cord loose
Plug in to the power supply again.
Excessive Vibration
The fan blade is damaged.
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
The fan motor is not fixed
tightly.
Switch off the unit. Repair to be
carried out by qualified service
personnel only.
The unit is not hung
properly on the bracket.
Take down the unit and check
whether the bracket is in proper
location.
Suction performance
not good
1 Grease filters clogged?
2 Distance between the
unit and the cooking plane
too great.
1 Clean or replace grease filters.
2.Adjust the distance to between
cooking surface to hood.
