9
CHARGING DOCK
The charging dock must be positioned on an even
floor surface against a wall with at least a 60 cm (2
ft) clearance around. Connect the AC adaptor to
the power socket on the rear side of the dock or
robot. Only use the AC adaptor provided by the
manufacturer.
The LCD display on the charging dock will turn on
when it is plugged in. Always keep the dock
plugged in.
Docking Test
Leave the robot on the floor somewhere near the dock. Press the "Home" button on the remote control.
The robot will return to the dock automatically.
If the robot fails to dock, check the installation process to make the necessary adjustments to the docking
station until the robot can dock properly.
Robot Battery Recharge
When the Power Button on the robot blinks red, this indicates that the battery level is low. The robot will
shut down the vacuum engine and go back to the recharging home dock. The AC adaptor can be plugged
into the robot directly to recharge the battery.
When the battery is fully recharged, the Power Button will light up a solid blue. The recharging process
takes around 3 hours.
Robot Battery Care
A high capacity rechargeable battery pack is used in this robot. The battery can last for hundreds of
recharging cycles if it is properly cared for.
Recharge the battery as soon as the robot is used. Keep the robot charged when not in use.
If the robot will not be used for a longer period of time, remove the battery from the robot and store it in a
cool and dry place.
Notes:
1. Charge the robot for at least 24 hours before the first use.
2. Each time the battery is fully depleted charge for at least 3 hours.
3. Never use the robot in temperatures less than 0
℃
or over 40
℃ as this will
reduce the battery life and
performance.
4. It is normal for the temperature of the charger to increase during the charging process
Notes
: All the settings are disabled while battery is charging.