11
ZONE DIVIDER (Available Separately)
The zone divider is available seperately from the same retailer as the Robotic vacuum cleaner. It creates
an invisible ultrasonic barrier (Virtual Wall) that the robot vacuum cleaner will not cross.
1. The zone divider is powered by 2 AA batteries. Make sure to install the AA batteries with the correct
polarity.
2. To turn on the zone divider, slide the power switch to “ON” position.
3. When turned on, the blue LED light blinks for 70 seconds, then turns into standby mode. When the
robot vacuum cleaner starts working, the Virtual Wall will turn on and shows blue LED light.
4. The best effective distance of Virtual Wall barrier is about 2.5M
5. The LED light will blink when the Zone Divider is low on battery.
You can charge the zone divider battery by plugging the zone divider into charging base (when rechargeable
batteries are installed), please see the figure above.
Step 1: The power switch of Zone Divider must set to "ON" position. Step 2: Press and slide out the DC Plug
from charging dock.
Step 3: Plug the DC Plug into DC Inlet, the LED light will blink. Step 4: When recharge is complete, LED will
glow continuously.
6. When the robot vacuum is cleaning, the zone
divider must be positioned at least 1m (3 ft) away
from charging dock and must not be facing the
charging dock.
7. When the robot completes the cleaning cycle you can power off the zone divider by sliding the power
switch to "OFF" position. When the robot detects the invisible barrier, it will turn around and move to
another direction.