ElectrIQ DESD9L, User Manual, Page: 15 / 21

15
WATER DRAINAGE
When the water tank is full, the unit will stop operating. When this happens the TANK FULL
light will show on the control panel, and the unit will bleep.
Note: Only empty the water tank when it is full or before moving or storing the unit.
There are two ways to dispense collected water.
USE THE INTERNAL WATER TANK
When the tank is full, the unit will stop running, and the TANK
FULL indicator light will display. Grip the tank securely, and
carefully pull out. Empty the water tank and reinsert it into the
dehumidifier. The tank must be in place and securely seated for
the dehumidifier to operate again. The dehumidifier will re-start
when the tank is restored to its correct position.
NOTES:
 Do not remove the water tank immediately after the unit stops.
Please wait a while to avoid the water dripping into the unit and
causing damage.

Only empty the water tank when it is full or before moving or storing the unit.

Do not rest the tank on the floor because the bottom of the tank could be uneven and the
tank may fall, causing water to spill.

When you remove the tank, do not touch sensors or any parts which are situated behind
tank. Doing so may damage the product. Be sure to push the tank gently all the way into
the unit. Banging the tank against anything or failing to push it securely into place may
prevent the unit from operating.

Do not remove or damage the float switch in the water-tank, otherwise the machine will
stop working.

Please make sure the water tank cover is put back into place correctly before the water
tank is reinserted.

If the water-tank is inserted incorrectly, the tank full indicator will illuminate. Remove the
water tank and reinsert to turn the indicator off and resume normal use.

At all times, avoid water entering the unit. It may cause an electrical hazard and damage
the unit.