❏
❏
7. Install a Screw-Lock pushrod connector in the outer
hole of each aileron control horn. Position the connector
body on the outboard side of the horn. Secure it to the horn
with a plastic retainer, placing a 2mm washer between the
horn and the retainer.
❏
❏
8. Install a 1 x 65mm Z-bend pushrod through the
outer hole
of each aileron servo arm. Connect the pushrods
to the ailerons.
Install the Strut Mounts
A
FORWARD
Upper Wing x 12
Lower Wing x 4
Lower Wing x 4
B
C
❏
1. Locate the twelve strut mounts marked “
A
.” Test fi t
these in the bottom of the
top wing
as shown. When you’re
satisfi ed with the fi t, glue these to the wing using thin CA.
❏
2. Install the four strut mounts marked “
B
” in the top of the
lower wing in the LE slots. Use the sketch above to help you
orient these properly before you glue them. Install the “
C
”
strut mounts in the TE slots of the lower wing.
INSTALL THE WINGS
❏
1. Prepare the eight interplane wing struts as shown using
sixteen 2 x 7mm sheet metal screws. Attach the interplane
wing struts to the
upper wing
on the outboard side of each
strut mount. Do not tighten the struts yet.
14