www.electricwingman.com
When done click Disconnect and unplug the LiPo. If you changed any motor
directions pop back into ButterFlight and retest them.
Configuring the FPV components
NOTE: Never power a video transmitter without an antenna attached, it will burn out
the transmitter.
Set up your goggles and receiver on the channel and band you want to use.
Following the instructions that came with the VTX, WITHOUT PROPS ON, plug the
LiPo in and use the button on the the VTX to set the band and channel on the
transmitter, the image will appear in the goggles when correct. (note that the image
may appear when you are on the wrong band and channel because the frequency is
close, this will be fine on the bench but will have dramatically less range. Use the
LED on the VTX and whatever mechanism is on your goggles to confirm they are on
the same band and channel with the image in the goggles as confirmation.
On the camera connect the OSD cable, and switch off the OSD components (you
don’t want two OSDs and the Flight controller OSD is more useful)
Summary of Contents for FlightClub PROton
Page 13: ...www electricwingman com...
