Electric Mobility Rascal Veo, Owner'S Manual, Page: 16 / 36

16
Rascal Veo, Veo X & Veo Sport Scooter
Assembling your Scooter following Transportation
1. Loosen the tiller thumb-wheel and raise the tiller to the desired position - now re-tighten the
thumb-wheel to lock the tiller in position (Fig 1).
2. Pull and twist the tiller transit lock to allow for normal steering , unlocked, it will allow steering to
fully move (Fig 2)
3. Re-connect the front and rear chassis sections by reversing the procedure in the previous section. (Fig 3).
4. Rotate the battery securing clamp so it will not foul the battery.
5. Lift the battery pack into position
6. Rotate the battery securing clamp so that it is pushing down on the top of the battery pack casing ,
tighten the battery securing clamp in position (Fig 4).
7. Replace the seat by squeezing the seat swivel lever and lifting the seat into position on the seat
post , (Fig 5) the seat should drop into position. Release the swivel lever and rotate the seat until it locks in
position . The seat should now only swivel if the lever is compressed / squeezed. Repeat this procedure if
the seat fails to lock on the first attempt. - Never drive the scooter unless the seat is properly installed and
locked against swivelling!
8. Fold the seat-back into the vertical position and ensure that the armrests are correctly adjusted
and secured.
9. Fit the basket and lock in position by pushing down on the top edge gently (Fig 6).
Warning!
Assembling the scooter involves lifting and handling heavy parts. Your dealer should advise you
on the best way to assemble your scooter.
Warning!
Pinching or Crushing. Be careful to avoid being pinched or having your hands crushed when
lifting or handling parts. Wear gloves whenever possible.
Warning!
Never unload your scooter on sloping or uneven ground. It could run down the slope and
injure someone.
1 3
6 5 4
2