B L U E W I N D O W O P E R A T I O N A N D I N S T A L L A T I O N M A N U A L
6
VERY IMPORTANT
:
Before you plug or un-plug any
connectors to the housings on the computer, you need to make sure
the high voltage has been disconnected. This is done by following
these 3 steps:
1.
Turn off the ignition.
2.
Turn off the circuit breaker.
3.
If vehicle comes with manual disconnect, you must
disconnect it as well.
4a) Isolated Battery & Shunt Connections
J2 on the Blue Window is used for making the High-Voltage and
shunt connections. While the 4-pin male connector is
UNPLUGGED
from the board, connect the battery and shunt wires
(+ and – for each) into their respective locations, designated by J2 in
Figure 2
. Use one of the included inline fuse holders with 1Afuse to
wire the BT + line. See
Figure 3
for a diagram of how all the
connections should be integrated.
