Model Number
Serial Number
Figure 1
NOTE:
A 15 Amp, 120 Volt alternating current (VAC) circuit is
required. A dedicated circuit is preferred but not essential in all
cases. A dedicated circuit will be required if, after installation, the
circuit breaker trips or fuse blows on a regular basis when the
heater is operating. Additional appliances on the same circuit may
exceed the current rating of the circuit breaker.
WARNING:
Ensure the power cord is not installed so that it is
pinched or against a sharp edge and ensure that the power cord is
stored or secured to avoid tripping or snagging to reduce the risk of
fire, electric shock or injury to persons.
Construction and electrical outlet wiring must comply with local
building codes and other applicable regulations to reduce the risk of
fire, electric shock and injury to persons.
Do not attempt to wire your own new outlets or circuits. To reduce
the risk of fire, electric shock or injury to persons, always use a
licensed electrician.
Fireplace Installation
1. Make sure the unit’s Main ON/OFF Switch is switched OFF (refer
to operating instruction section).
2. Plug the unit into a 15 Amp/120 VAC outlet. If the cord does not
!
4
