14
CAUTION!
Use 2 appropriate clamps to hang the fixture on the truss
！
Make
sure that the device is fixed properly! Ensure that the structure
(truss) to which you are attaching the fixtures is secure.
Installation instruction
I. Clamp (optional)
II. Omega holder
III. Drill holes
IV. Safety cable (optional)
V. Base
VI. Holes for Safety cable
VII. Safety cable (optional)
VIII. Omega
Remark:
For safety concern, the safety cable should
hold at least 12 times of the weight of the
fixture. The extended length shall not
exceed than 20cm.
MAINTENANCE AND CLEANING
CLEANING
-It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid residues
must not build up on or within the fixture. Otherwise, the fixture's light-output will be significantly
reduced. Regular cleaning will not only ensure the maximum light-output, but will also allow the
fixture to function reliably throughout its life. A soft lint-free cloth moistened with any good glass
cleaning fluid is recommended, under no circumstances should alcohol or solvents be used!
-The front lens will require weekly cleaning as smoke-fluid tends to building up residues, reducing
the light output very quickly. The cooling-fans should be cleaned mother.
-The interior of the fixture should be cleaned at least one time per six month using a
vacuum-cleaner or an air-jet.
-Dichroic color filters, CMY filters, gobo wheels and the internal lenses should be cleaned monthly.
-The PCB need to be cleaned every three months sting a soft brush and vacuum-cleaner.
-Remove dust and dirt from the fans and cooling vents using a soft brush and vacuum-cleaner.
-Clean the air filters placed in the fixture's covers. Use a vacuum cleaner, compressed air or you can
wash and put back dry.
REPLACE THE FUSE
DANGER
！
Disconnect from the mains before starting any maintenance work
USER MANUAL - BEAM 300 / BEAM 700
