5. Transmission from multiple audio / video sources (page 5)
If you wish to transmit the sound and picture from several A/V units to a second TV set, connect them according to the
schematic below. Usually, the units are connected in series. Connect the transmitter with its double SCART adapter to
the appliance linked to the TV.
An optional SCART Switching Box SSB1 is available to select individual sources.
6. Troubleshooting :
The quality of the picture or the sound on the second TV is poor :
- Try the other channels ( A, B, C or D) on both the transmitter and the receiver
- Point the 2.4 GHz antennas in the same direction
There is no picture on the TV :
- Are the transmitter and the receiver connected to the mains, are they switched on
- Did you select the same channel for the transmitter and the receiver
- Is the receiving TV on the correct A/V channel ?
You cannot change of channel easily :
- Change the LED position in front of the A/V sources
- Raise the small black side antenna to an upright position.
If you have problems with the range, try to move the receiver and/or transmitter away from your connected equipment.
This can greatly increase performance of the radio transmission.
7. Technical Data
Transmitter VTD33 / Receiver VR36 Power supply Transmitter 230V AC / 12V DC 200mA Power supply Receiver
230V AC / 9V 400mA
Europe 4 channels:
channel A : 2.411 GHz
channel B : 2.433 GHz
channel C : 2.453 GHz
channel D : 2.473 GHz
Spain 3 channels:
channel A: 2.421 MHz
channel B: 2.449 MHz
channel C: 2.477 MHz
Bandwidth:
18MHz
Power output: 10mW
IR Extender:
433.92MHz
Power output: <1mW
UHF modulator:
Channel 36 (Europe)
Channel 48 (UK)
AV-Input : 1 DIN input (3 RCA Plug (2 Audio 1 Video)) Modulation: FM Video Input/Output: 1Vpp (type) /
75 Ohms Audio Input/Output: 1 Vpp (type) / 600 Ohms
Dimensions: 35 x 95 x 90 mm Weight: 175g
