GB Remote Controller (RCA-15)
The Remote Controller is used to remotely arm or disarm the system, activate the panic alarm, and put the system in the "HOME" mode.
Identifying the parts
1.
button
Pressing this button will put the system into the Armed mode.
2.
button
Pressing this button for 3 seconds will trigger the panic alarm
regardless of whether the system is Armed, Disarmed or
Home.
3.
button
Pressing this button will put the system into the Home mode.
4.
button
Pressing this button will put the system into the Disarmed
mode. If the alarm is sounding, pressing this button will stop
the alarm (except when the alarm situation was caused by
pressing the Panic button on RCA-15).
5.
TX-Indicator
6.
Battery compartment
TX Indicator
When any of these four buttons is pressed, TX LED will on. Please hold the button until the TX LED is off to indicate the Remote Controller has successfully sent out a
signal to the Main Unit.
<
<
N
N
O
O
T
T
E
E
>
>
Press & hold the Panic button for one second then release. The Tx LED will light on for one sec., press & hold the Panic Button (one sec) again
Battery
The Remote Controller uses one “CR2032” 3V 230 mAh Lithium battery as its power source. Battery life is over 2 years in a normal domestic environment.
The low battery status will be sent to the Control Panel along with regular signal transmission, and, the Control Panel will display the status accordingly.
Getting Started
Remove the battery cover by using a coin to turn counter-clockwise.
Insert the battery as shown in diagram, with unmarked side (negative) of the battery facing down.
Replace the battery cover – secure the cover by using a coin to turn clockwise.
Put the Control Panel into “/-“ menu and then select “Add Device” menu.
Press any buttons on the Remote Controller.
Please refer to the operation manual of your control panel under the section of “/-“ to complete learn-in process.
