T
ROUBLE
S
HOOTING
Heating device will not switch to HEATER ON mode
In most cases this will be the result of one of the following not being met.
Possible Cause 1.) The required temperature has been achieved.
To confirm that the Pool-Smart is requesting the heating device to heat check that the window
next to the word HEAT is illuminated (see diagram below). If illuminated go to step 2, if not illu-
minated increase the required temperature to a value higher than the current water temperature.
Confirm whether the heating device now switches on
Possible Cause 2.) Insufficient Flow.
The display will display a NoFL alarm message in the upper (red) display window when the
Pool-Smart has detected that the flow rate has dropped below 4,000-litres per hour or has stopped
completely.
Useful advice: To reduce running costs and speed up the heating process ;
Insulate the pool wherever possible. A floating solar cover is an essential minimum to retain
heat.
R
O
HS C
OMPLIANCE
S
TATEMENT
W
ASTE
O
F
E
LECTRICAL
/ E
LECTRONIC
E
QUIPMENT
This product complies with EU directive 2002/96/EC
Do Not dispose of this product as unsorted municipal waste.
This symbol on the product or on it’s packaging indicates that this product should not be treated
as household waste. Instead it should be handed over to the applicable collection point for the re-
cycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly you will help prevent potential negative conse-
quences for the environment and human health, which could otherwise be caused by inappropri-
ate waste handling of this product. The recycling of materials will help to conserve natural re-
sources. For more information please contact your local Civic office, your household waste dis-
posal service or the retailer where you purchased the product.
Elecro Engineering Limited certify that our Electric Swimming Pool Heater Range complies in
accordance with RoHS Directive 2002/95/EC on the restriction of hazardous substances.
HEAT = If Continuously Illuminated
Indicates that the water temperature has fallen below
the required temperature.
HEAT = If Flashing
Indicates that the heater is in timed delay mode (see
previous page).
REQUIRED
TEMP
PRIORITY OF HEATING
