Portable Conductivity/TDS Meter
513-160
24
9907X0094 Issue 2
The decimal point blinks.
The display shows the conductivity of the sample.
If the automatic endpoint is chosen, and the signal has stabilized,
the display freezes,
appears and the decimal point stops
blinking.
In case the
Read
button was pressed before the automatic
endpoint, the display freezes and
appears.
Note
Press and hold
Read
to switch between the automatic and manual endpoint
format.
5.3.3 Performing a TDS measurement
An electrode is connected to the instrument.
Make sure that the TDS mode is selected and the correct TDS factor is
entered in the settings TDS factor (5.1.6).
-
Perform the same steps as described in the section Performing a
conductivity measurement (5.3.2).
5.4 Using the memory
5.4.1 Storing a measurement result
The instrument can store up to 200 endpointed results.
- Press
STO
when the measurement has endpointed.
M001
indicates that one result has been stored, and
M200
that
the maximum of 200 results have been stored.
Note
If you press
STO
when
M200
is displayed,
Err 6
indicates that the memory is
full. To store further data you will have to clear the memory.
5.4.2 Recalling from memory
1) Press and hold
RCL
to recall the stored values.
2)
Press ˄ or ˅ to scroll through the stored results.
MR 001
to
MR 200
indicates which result is currently displayed.
3) Press
Exit
to go back to the measurement screen.
