Humidity Cabinet
39-1300, 39-1601
5
9907X0093 Issue 3
3.1
The JUMO dTRON 316 microprocessor temperature controller on your incubator has
two LED displays. The upper display, which is red, represents the actual chamber
temperature. The lower display, which is green, represents the target temperature.
The controller has 4 buttons marked as follows;
PGM
-
Program button (Enters the programming mode).
▲
-
Increases the temperature set point
▼
-
Decreases the temperature set point.
EXIT
-
Exits the programming mode.
The
yellow 3
on the temperature controller shows when heat is being supplied. The
yellow 5
shows when cooling is being supplied.
3.2
The incubator operating temperature or set point (SP) can be altered by simply
pressing either the ▲ button to increase the temperature or the ▼ button to decrease
the temperature. When the required temperature has been entered, release all
buttons and the green display will blink once to confirm that a new target temperature
has been stored.
3.3
Over / Under Temperature Safety Cut Out
A TLK38 digital safety cut out unit provides essential over & under temperature
protection for the products inside the chamber. The cut out has buttons labelled as
follows:
P -
Enters the programming mode.
U -
No function.
▲
-
INCREASES
the displayed value.
▼
-
DECREASES
the displayed value.
