14
800.925.1491
|
F I R E P L A C E I N S T A L L A T I O N S T E P S
Continued
Parts:
1 qty. Isokern Damper Beam (Part 4) +
2 qty. Isokern Damper Supports (Part 5)
Mortar Type:
Isokern Mortar
a) Dry-set a Damper Support in position on top of both the right
and left walls of the firebox wall assembly. Rest a Damper Beam
across the rear of the firebox wall assembly. All exterior edges
of the damper components must be flush to the exterior edges
of the firebox wall assembly.
b) Once all pieces are in position, remove the Damper Support on
the left and apply Isokern Mortar to the bottom and vertical
contact surfaces; set back into position. Repeat this process
for the Damper Support on the right and the rear Damper
Beam.
NOTE:
Leave the front Damper Beam off until after Step 12 has
been completed.
Parts:
Cross-Section Sleeve (Part G) +
4 qty. Bolts, 8 qty. Washers & 4 qty. Nuts
Mortar Type:
Construction Adhesive
a) Lift the Cross-Section Sleeve up and over damper assembly and
set in place on top of the Fireplace Left (Part D) and Right (Part
E) Side Units. The Cross-Section Sleeve should sit flush with both
Left and Right Side Units and Back Panel.
b) Apply construction adhesive to the bottom of the Cross-Section
Sleeve and set in place making sure to line-up all appropriate
bolt holes.
c) Using access openings, connect the Cross-Section Sleeve to the
Left and Right Side Units with 4 bolts, using 2 washers and a nut
for each bolt. Tighten with a ¼ turn past snug.
P L A C E C R O S S - S E C T I O N
S L E E V E
12
C O M P L E T E I S O K E R N
D A M P E R A S S E M B L Y
Parts:
1 qty. Isokern Damper Beam (Part 4)
Mortar Type:
Isokern Mortar
a) Once the Cross-Section Sleeve is bolted in place, use Isokern
Mortar on the last remaining Damper Beam and set it in the
front position of the damper assembly.
13
B E G I N I S O K E R N
D A M P E R A S S E M B L Y
11