TECHNICAL DATA
- supply voltage: 230 V ~ 50 Hz
- power: 6 W
- battery: 1000mA, Ni-Mh
- charging time: 8 hours
DESCRIPTION OF THE SET
R
1. Cutting head
2. Hair length control ring
3. Switch-key
4. Control lamp
5. Comb heads (3 mm, 6 mm, 9 mm, 12 mm)
6. Feeder
7. Maintenance oil
8. Cleaning brush
9. Battery
Before the first use, put the battery in, phot. 1.
The Hair Clipper MG10 can be used as an appliance powered
by electricity or a battery. If the appliance is powered
by electricity, it is ready to be used right away.
ELECTRIC POWER SUPPLY
- Turn off the appliance, the switch-key
(3)
in position “0”.
- Plug in the feeder
(6)
and connect it to the hair clipper.
- Power supply is signalled by the red control lamp
(4)
.
- To start operation, turn the switch-key
(3)
to position “1”.
CHARGING AND OPERATION WITH THE BATTERY
- Turn off the appliance, the switch-key
(3)
in position “0”.
- Plug in the feeder
(6)
and connect it to the hair clipper.
- Charging is signalled by the red control lamp
(4)
.
Battery charging time: approx. 8 hours
NOTICE: The control lamp (3) does not go out after the battery has been charged.
- After the battery has been charged, disconnect the feeder, the appliance is ready for
operation with the battery. To start operation, turn the switch-key
(3)
to position “1”.
Charging the battery for over 12 hours reduces its life span.
If the appliance is not used for a longer period of time, it is recommended to charge the battery
at least once every half a year. Failure to charge the battery for a period of over 6 months also
reduces its life span.
HOW TO USE THE APPLIANCE
INSTRUCTIONS FOR USE
HAIR CLIPPER MG10
3
4
5
6
7
8
1
5
2
9
phot. 1
