1
3
5
6
4
2
USER’S MANUAL
Hairdryer HT140
Before the first use, please read all these instructions carefully:
- the cord should be plugged into the power supply of parameters indicated in the data plate,
- the appliance should not be dropped into or sprayed with water,
- WARNING: do not use close to bathtubs, showers, swimming pools and other water containers.
- do not expose to sunrays, hot surfaces and damp,
- air intake and outlet vents must not be covered or blocked.
- do not leave the operating appliance unattended,
- this appliance is not intended to be used by persons (including children) with limited physical, sensory or
psychical abilities, unless they are in the care of a person responsible for their safety. Make sure children do
not play with the appliance;
- this appliance is intended for household use only,
- do not use outdoors,
- use with original accessories only,
- in case air intake vents are blocked, the automatic safety device will shut the dryer off. The switch
(1)
should be set to “0” position and the appliance unplugged. After cooling (a few minutes)
the appliance can be turned on again.
- if used in a bathroom, it needs to be unplugged after the usage, as proximity of water can be dangerous
even if the appliance is switched off,
- for additional protection, it is advisable to install a residual-current device (RCD) of nominal operation
residual current not greater than 30mA in an electric circuit. Turn to a qualified electrician to help you.
- do not use the appliance with a power cord damaged. To avoid danger, replace it in a service centre.
do not open or fix the hairdryer on your own (warranty rights can be lost),
in case any technical problems occur, please turn to an authorized service centre; repairs can be done
only by an authorized service centre.
Any modernizations or usage of other than original attachments or elements of the appliance are forbidden
and dangerous for the user.
GENERAL DESCRIPTION
1. On/Off switch with power settings
2. Feeding cord
3. Hang up loop
4. Folding handle
5. Air inlet
6. Concentrator
3
OPERATION GUIDE
The hairdryer is intended for drying hair.
Before connecting the appliance to the power supply,
make sure that the switch
(1)
is set to „0" position.
After connecting to the power supply, of parameters indicated in the
instructions, turn on the appliance with the switch
(1)
.
0 position
- the dryer is off.
1 position
- low speed,
2 position
– high speed,
The concentrator
(6)
helps to style hair. The hairdryer can be used
without the concentrator. The folding handle
(4)
helps with storage.
SAFETY INSTRUCTIONS
TECHNICAL DETAILS
- rated power 1200W
- mains supply: 230V ~ 50Hz
CLEANING AND MAINTANANCE
- before cleaning unplug the hair-dryer and wait until it cools down completely
- never immerse the hair-dryer in water
- casing and power cord can be cleaned with soft dry or slightly damp cloth
- the air inlet and outlet should be cleaned with soft brush
- the device is made of materials that can be reused or recycled
- it should be handed to the special collection point, that deals with collection
and recycling of electronic and electric devices.
ENVIRONMENT PROTECTION
CAUTION: Do not use the appliance near bathtubs, showers,
swimming pools and similar water reservoirs.
