eldoLED LINEARdrive, User Manual

Page: 24 / 46

24
3.4 Replacing the strain reliefs
To replace the strain reliefs:
1. On both sides of the LINEARdrive, make sure the leads run between the strain reliefs’
screw holes.
2. Place the strain relief over the leads.
3. Fasten the strain reliefs’ screws.
4. Replace the LINEARdrive’s cover.
Figure 3.7: Fastening the strain reliefs
2
1
LINEARdrive 720D
Ext in + Ext in
DMX in +
DMX in -
DMX in shield
LedSync out +
LedSync out -
LedSync shield
-
DALI out -
DALI out +
DALI in -
DALI in +
TC
Group 1
Group 1 GND
Group 2 -
Group 2 GND
Group 3 -
Group 4 GND
Group 4 -
Group 3 GND
12-28V / 24A Direct voltage controlled LED driver