USER MANUAL EWD1 V1.0
5
Here “ID1” means magnetic door contact identification number. This identification number can be found on the back of the device.
The system automatically provides two security zones to the connected door contact. The system informs about this via SMS messa-
ge, for example, “ID1:Z14:ID1Z15” - here instead of “ID1” will be identification number of the module that you want to connect, “Z14
and Z15” – the numbers of free zones provided by the system.
You can bind more than one magnetic door contact at a time. In such a case separate identification numbers by “;” symbol, for exam-
ple: “ XXXX SET:ID1;ID2; ... ;ID16 ”.
4.2. Settings of Activated Zones
After activating magnetic door contacts EWD1 each of them is automatically given zones numbers and set to the default settings.
4.2.1. Adjusting Alarm Text
Alarm text of a particular zone is adjusted by sending the following SMS message:
Here instead of “Text” enter the required alarm text consisting of up to 24 characters and instead of “Z2”
indicate the number of the corresponding zone. You receive this alarm text by SMS message when a
corresponding zone is triggered. To change alarm text of more than one zone separate entries by “;”
symbol, for example: “XXXX Z2:Text2;Z3:Text3”.
4.2.2. Enabling/Disabling Zones
You can choose which zones, after activating the alarm in the whole system, will be enabled or disabled.
By initial factory default parameters all activated zones are enabled.
Any zone can be enabled by sending SMS message with the following format*:
Any secured zone can be disabled by sending SMS message with the following format*:
* Indicate as many zones as you want to change their statuses separating entries by “;” symbol, as shown in the examples provided.
4.3. Requesting system status information
To find out the alarm texts and statuses of activated zones, send the following SMS message:
You will receive system response via SMS message, for example: “Z1:ON/OFF:Zone1; Z2:ON/OFF:Zone2;
C1:ON/OFF:Controller1; C2:ON/OFF:Controller2“
This information SMS message indicates all wireless ELDES devices connected to the system and their
current parameters.
ATTENTION:
System informs about all active zones. If there are many active zones, the system informs about all of them in several
SMS messages.
4.4. Requesting number of available slots to connect wireless devices
To find out the number of available slots to connect wireless devices to the central device of security system send the following SMS
message:
NOTE:
maximum number of wireless devices that can be connected to the central device of the security system station is 16 units.
EWD1
EWD1
EWD1
1111 Z5:
Doors
opened
1111 Z2:
ON
1111 STA
TUS
XXXX_Z2:TEXT
XXXX_Z1:ON;Z2:ON;Z3:ON
XXXX_STATUS
XXXX_STATUS_FREE
XXXX_Z1:OFF;Z2:OFF;Z3:OFF