MANUAL ELDES ESIM010 V1.2
19
EN
2.7 Sending Messages from Any Phone Number
The system is set so that the relay of the unit can be controlled only by the users entered on the system. However, it is possible tur
-
ning on a special mode the relay can be turned on by any caller calling to the SIM card number of the device.
To turn on this mode send the following SMS message:
To turn off controlling from any phone send the following SMS message:
2.8 Input Status
To find out current input names and their settings send the following SMS message:
You will receive the answer, e. g.:
Z1:Zone1:ON/OFF T1:600 Z2:Zone2:ON/OFF T2:600 Z3:Zone3:ON/OFF T3:600
T1, T2 and T3 – delay of particular input in milliseconds, i. e. a period during which the input starts reac
-
ting to signal change. For instance, the alarm will be triggered just in the case when voltage (signal) is
supplied for at least 600ms.
2.9 Changing input names
Input names set by the manufacturer: Z1- Zone1, Z2-Zone2, Z3-Zone3. Any of these names can be changed by the user. The names
cannot repeat or coincide with control commands.
Input names can be changed by sending the following SMS message:
The user can change all names at once, several names or only one name. Maximum input name length
is 8 characters.
E. g. XXXX_Z2:OpenGate
2.10 Input arming/disarming
Input arming
Any of the inputs can be armed by sending the following SMS message:
E. g. XXXX_Z2:ON or XXXX_doors:ON
Input disarming
Any of the inputs can be disarmed by sending the following SMS message:
E. g. XXXX_Z2:OFF or XXXX_doors:OFF
XXXX_STATUS
XXXX_Z1:ON_Z2:ON_Z3:ON
XXXX_Z1:OFF_Z2:OFF_Z3:OFF
XXXX_Z1:NewInputName_Z2:NewInputName_
Z3:NewInputName
ESIM 010
XXXX_
STATUS
ESIM 010
XXXX_Z2:
OpenGate
ESIM 010
XXXX_Z2:
ON
ESIM 010
XXXX_Z2:
OFF
XXXX_ALLNUM:ON
XXXX_ALLNUM:OFF
