Select brightness and time values
SET BRIGHTNESS (lux)
You can set different brightness values (lux) with
the potentiometer.
If you wish to change the preset brightness
(15 lux default):
- Set potentiometer to desired brightness
(5 – 1000 lux).
or
Wish a specific brightness value to be learned
using the teach-in function:
- When the brightness is at your preferred
level, set the potentiometer to
.
The value will be learned after 15 seconds.
-
Leave potentiometer at position
.
15 100
7
1
11
0
00lu
x
teach-in
1000 Lux
5 Lux
500 Lux
7 Lux
100 Lux
10 Lux
15 Lux
50 Lux
15 Lux
SET TIME (min)
If the motion detector detects no further move-
ment, it switches off after the set time
.
If you wish to change the preset time (2 min de-
fault):
- Set potentiometer to preferred
time (0.5 s – 20 min).
or
If you want to use the pulse function (e.g. for a
staircase light time switch):
- Set potentiometer to position
. The motion
detector is switched on for < 1 s, then off for 9
s. If it detects a movement again, it switches
on again for 1 s.
2
10
20
30s
test
mi
n
test
20 min
1 s
15 min
30 s
10 min
1 min 2 min 5 min
2 min
Adjust detection zone
WALK TEST
The walk test is used to test the detection range
and to restrict it if necessary.
After switching on the power supply,
the motion detector is switched on for
at least 40 seconds or for the set time.
Do not start the walking test until the
motion detector has switched off!
1. Set the potentiometer time (min) to test.
The motion detector now only reacts to move-
ment (independent of brightness).
Test
2
10
20
30s
test
mi
n
2. Walk across to the detection area. After the
motion detector has detected a movement, it
switches on for 2 s. Note direction of motion
during the test.
0
2
Sec
2 sec
3. If you wish to adjust the detection range to
your requirements, realign the sensor head.
ALING THE SENSOR HEAD
The sensor head can be tilted down by 30°
30
30
and left and right by 90°.
90
90
Disposal
Waste electronic equipment must not be
disposed of with household waste!
Dispose of the waste product via collec-
tion facilities for electronic scrap or via
your specialist dealer.
Dispose of packaging material in the
recycling bins for cardboard, paper and
plastic.
Warranty
Within the statutory warranty period we undertake
to rectify free of charge by repair or replacement
any product defects arising from material or pro-
duction faults. Any unauthorized tampering with,
or modifications to, the product shall render this
warranty null and void.
Conformity
Hereby, ELDAT GmbH declares that the radio
equipment type ST01 is in compliance with Direc-
tive 2014/53/EU.
The full text of the EU declaration of conform-
ity is available at the following web address:
www.eldat.de
Customer service
If the device does not work properly despite
proper handling, or in the event of damage, please
contact the manufacturer or your retailer.
SETTINGS
GENERAL INFORMATION
