re-start in 10 seconds.
3. Reverse Connection Protection: When the battery is
polarity reversed, the charger will disconnect the internal
circuit and the battery, the charging will stop and avoid been
damaged.
4. Input Low-voltage Protection: When the input AC Voltage
is lower than 85V, the charger will shutdown protectively
and automatically resume working after the voltage is
normal again.
Alarms
Note:
1. R—red G—green
2. “_” denotes one second stop
3. Above LED flashing sequence is one cycle, the LED will
flash repeatedly when in fault.
Choice of Charging Curve (curve 1~10)
1.The LED will flash red several times when AC is first
connected, then the LED will flash green once. The number
of red flashes denotes the present curve. E.g. If the red
flashes three times, it means the present curve is curve 3.
2.To choose another curve, please cut off the power supply
first, then unpeel the label, pressing the button while
connecting the power. If you want to choose curve 3,
release the button after the 3
rd
LED Flash. Now the selected
curve (e.g. curve 3) will be recorded in memory. If you want
the charger to work with the selected curve (e.g. curve 3),
cut off the power and reconnect it.
3. Factory customizes 10 charging curves before delivery
according to customer demand. These are 10 combinations
of voltage and battery size for the same battery type.
Installation & Safety Instructions
1. Preferably the charger should be installed in the vertical
position with radiator fins vertical. A space of 10cm above
ground should be open to ensure airflow. Never install in the
vertical position with fins facing down.
2. Ensure all heat dissipating parts are not obstructed to
avoid overheating. Do not put the battery charger near any
heat sources. Make sure that free space around the charger
is enough to provide adequate ventilation & easy cable
socket access.
3. Ensure the consistency between the alternating supply
voltage and the allowable voltage input of the charger.
Please approach a retailer or local Power Supply Bureau for
enquiry.
4. For safety and electromagnetic compatibility, the battery
charger has a 3-prong plug that apply to the socket with
grounded outlet.
5. If you are using an extension cord for alternating current
power supply, make sure that it is affordable to the
maximum input current.
6. The voltage-drop between the charger and connection
wire of the battery should be as less than 1% of the battery
voltage as it can. Otherwise, it affects charging effect
possibly. Meanwhile, the diameter of the wire should satisfy
the output current value.
7. The thermal compensation probe for the battery voltage
must be placed in the area of the highest battery
temperature, such as between 2 batteries near the center of
the pack.
8.If the charger does not work correctly or if it has been
damaged, unplugged it immediately from the supply socket,
from the battery and contact a retailer.
9. Do not try to service the charger yourself. Opening the
cover may expose you to shock or other hazards.
LED Flashing
Sequence
（
One
Cycle
）
Indication
1
R G _ _ _ _ _ _
Wrong Battery
2
R G R _ _ _ _ _
Overcharged
3
R G R G _ _ _ _
Battery Overheated
4
R G R G R _ _ _
Incorrect AC Input Voltage
5
R G R G R G _ _
External Thermal Sensor
Fault
6
R G R G R G R _
Communication Interface
Fault
7
G R _ _ _ _ _ _
Charger Overheated
8
G R G _ _ _ _ _
Charger Relay Fault
；
Repair
9
G R G R _ _ _ _
Charger Fault; Repair
ElCon
T C C H
PFC Charger
www.
evcomponents
.com
