Elcon Models 2008 ©
Assembly Air Brake
page: 2
2)
In order to get the engraved Elcon logo at the cover plate on top when assembled, it is wise to check first with
a quick test assembly without mounting screws.
Take one of the uprights, place the ground plate on it, the 2 holes for the air connection should be horizontal.
Take the cover plate and check if it can be mounted onto the pins of the ground plate correctly so the logo is
on top.
If not rotate the ground plate 180 degrees.
3)
The front hole is used to connect the airtube.
The rear hole must be closed.
Use the smal M5x4mm grub screw to close the hole.
Apply loctite (rich), so the hole will be fully closed against escaping air.