ELCOM Uniq PC 150, User Manual

Page: 44 / 48

The base of the Uniq PC is adjustable for different ways of placement and mounting. The basic ways of
mounting it are on a table or a wall. The packaging includes the components necessary for its comfortable
and easy placement on these types of basic surfaces.
There are other, less standard, solutions for mounting the panel, such as mounting on a body tube or using
a standardized VESA mount. For these ways of mounting the panel, however, a specially prepared base is
necessary for the Uniq PC supplied as a complete solution together with a specially prepared Uniq PC, be
it for placement on a body tube or by using a standardized VESA mount.
Figure 4.1 Possibilities for mounting
Note: for placing a Uniq PC on a wall it is necessary to achieve a larger angle curvature of the monitor by rotating
its legs by 180°. This operation is only authorized to be done at an ELCOM service center.
Placement on a vertical surface (wall) for standard stand
You’ll find in the packaging of the Uniq PC a number of 4 × 16 mm drive screws. For anchoring the panel,
it’s enough to place two screws horizontally at a distance of 176 mm from each other. The screws must re-
main screwed in by at least 2-3 mm, in order to hang the panel from them. The base of the Uniq PC has on
its bottom side metal slats with holes cut-out for hanging the panel. It may also be suspended in a position
rotated by 180° according to the method of use. Always suspend the Uniq PC such that the narrower side
of the screw holes is pointed upward; that is, always on the holes in the upper metal slat. It is possible to glue
one, or if necessary, more anti-slip sticky pads on the lower metal slats of the Uniq PC base. This ensures
the cushioned setting of the base on the surface.
44
Ways of mounting
&/(-*4)