I02-115 User manual & maintenance guide
Version 03
(translation of the original manual)
of TLM 1500
Page
5
sur 22
3.5
Workpiece carrier
1.
Check that the springs of the pins located under the carrier are working properly.
2.
Check that no part goes over the lower surface of the workpiece carrier.
4
MAINTENANCE
General visual check
Approximately every 500 hours, check the following points to ensure the proper functioning of the
transfer system:
4.1
Belts wear
Regularly verify visually the state of the belt and especially the welding area.
4.2
Passageways of workpiece carriers
The friction of the pins while operating can make some marks appear. Those marks may over the
long term require the part replacement.
4.3
Pins
Pins are sensitive to wear, especially if the load is heavy. Wear can be noticed as soon as a loss of
efficiency in the guiding of the workpiece carrier occurs.
4.4
Wear of the belt guide
Belt guide must be replaced as soon as wear marks or friction on the belt start to appear.
Wear area of the pins
Belt
Belt guide
