ELCOM Euro-2000T Alpha, User Manual

Page: 60 / 81

Euro-2000T Program manual © Elcom s.r.o.
60
Note l: If you switch off the register during the sorting, you can continue after switching the register on.
7.3. Programming of PLU name
After finishing programming of the PLU flags “ 001 3I50 ” appears in the display for example. The left-
hand side digits designate the PLU number and the right side is the data area for programming of the PLU
name (Graham bun, Jamaica RUM, Marlborro cigarettes, etc.). The name of each PLU can comprise up to
14 characters of standard size or 7 characters of double size.
Enter hexadecimal character codes from the alphabetic or hexadecimal character table and press the
V
button. After pressing the button, continue programming of the PLU bar code.
To check the set values print them out by pressing the
G
button in the PLU programming mode. To finish the
PLU programming press the
W
button.
N
0 1 47
0001
Display :
Programming first character of PLU1 name.
PLU
10000000
Display :
PLU 1 bar code programming.
PLU
0001
7.4 Programming of PLU bar codes
There are two methods of PLU bar code programming :
1. Programming by means of keyboard - the numeric digits of the bar code are entered manually
from the cash register keyboard
2. Reading of the bar codes from the package of the goods with the bar code scanner.
The cash register enables both methods of programming (by entering the bar code either of these methods is
understood).
The programming procedure :
Enter the bar code of the goods and press the
V
button. After pressing the
V
button, the cash
register verifies that the entered bar code is not assigned to any other PLU. If there is a duplicate PLU, the
“ D
U
P 0004 ” notification appears in the display. The “dUP” means duplication of the entered code and
0004 designates the PLU number to which it has already been assigned.
By pressing the
H
(CLEAR) button the register is returned to programming the PLU code of the item origi-
nally desired.
If the entered code had not been assigned yet to any other PLU, the register is continues to program the next
PLU. To exit the programming mode press the
W
button. After pressing it, the register starts to sort the
bar codes. Bar code sorting is notified by “
VAIT
” in the display. The sorting time depends on the number of
programmed bar codes. After sorting the register returns to the basic programming mode „P MODE“.
8 5 8 6 0 0 1 7 6 0 0 9 6