21
Start-up
Electronic burner controller
Description
The electronic burner controller is a
programmable automatic combustion
control unit with an integrated electronic
coupled controller. There may be addi-
tional functions, depending on the
equipment and model.
The following burner-specific controllers
are used:
Additionally, some burners are deli-
vered without a controller and all com-
ponents are connected to a terminal
block. The burner controller in this case
does not form part of the burner's scope
of delivery.
Commissioning
Commissioning must be carried out by
trained and expert personnel only. For
the wiring of the system, the relevant
electrical diagram for the burner and all
local standards and legal regulations
must be observed.
The procedure described in the relevant
operating instructions for the burner
controller must be observed.
The burner controller has a burner-spe-
cific factory setting. At the time of initial
commissioning, it must be checked
whether the parameters have been
appropriately configured to meet the
requirements of the system. The actua-
tors must similarly be chekked for cor-
rect adjustment.
During the I/O test, the manual gas
shut-off valves must be kept closed at
all times. It is not permitted to extend
fixed safety times using external cir-
cuitry.
Burner controller
BCS 300
Etamatic OEM
Manufacturer
Dungs
Lamtec
Technical Data
Operating voltage: 230 VAC
Operating voltage: 230 VAC
Frequency: 50/ 60 Hz
Frequency: 50/ 60 Hz
Power consumption: <16,5 VA
Power consumption: ca. 50 VA
Ambient temperature
Ambient temperature:
during operation: 0-60°C
during operation: 0-60°C
Storage: -20-70°C
Storage: -25-60°C
Mode of operation:
Continuous operation
Mode of operation:
Continuous operation
Components and integrated
functions
Flame monitor module FLW05
for connecting various
flame sensors
Actuator STM 30/40
Actuator SAD15
Customer interface
integrated power regulator
integrated power regulator
integrated valve leak check
integrated valve leak check
optional equipment
Operating and display module
Programming unit
Expansion module EM1 for speed
regulation and O
2
-regulation
Installation kit for speed control
O
2
-regulation
12/2011 14 072 205
Summary of Contents for Low-NOx N10.12000.30 G-EU2
Page 33: ...34 Manufacturer s declaration...
