ENG man E1-MIA 00
E1-MIA Radio Remote Control
- Page 11 -
ENGLISH
The devices of the series E1 with MTS (Multi-Transmitter System) enable multiple transmitters E1-MIA to command
the same receiver. All transmitters that compose the system are enabled to control the receiver, but only one at a time
exclusively and uniquely determined.
To the same receiving unit that is part of the MTS system you can match from a minimum of two up to a maximum of 15
transmitter units, these latter are identified by “Unit n.1” up to “Unit n.15”. The identification of the transmitter is shown in
the data label near the serial number
When powered, the receiving unit is in free state and can be engaged by the first transmitting unit that performs the
enabling sequence. From this point on, the transmitter unit that takes control commands exclusively the receiver and no
other transmitter unit can take over or interfere with the operation.
To free up the receiving unit it is mandatory that the transmitter, which had taken over the command, performs the
operation of voluntary release by pressing and holding down the START button and by pressing twice K7 button. The
release is indicated by the turning off of the receiver and the transmitter.
Free again, the receiver is ready to be controlled by any other matched transmitter that performs the enabling sequence.
4.2 EQUIPMENT WITH MTS SYSTEM (MULTI-TRANSMITTER SYSTEM)
Command layout
FULL version
FULL VERSION
.
In the FULL version you can have the first four rows of buttons, 2-step second-click com
-
mands that activate a different output for each key (second speeds separated).
On the receiver, the outputs for K16 to K23 are available on the optional relay card in-
stalled on the J15 connector
