REBLE610 Fully indoor Microwave Link
Page 11 of 52
Version 1.4
Max power consumption
100 W
Max dissipation
110 W
5.4
Mechanical Specifications.
Table 7
Rack
Standard 19” 1U
Width
482.6 mm
Height
43.6 mm
Depth
554.85 mm (with circulator and hangings)
512.85 mm without circulator
Max Weight
8 Kg
6
Installation.
Unpack the equipment and check first of all check if there are any damages due to the transport.
The box should contain
:
o
The REBLE610
o
1 or two AC supply cable (depending on number and type of power supplies purchased)
o
1 or two DC supply cable, equipment adapted connector on one side, free wires at other
end (depending on number and type of power supplies purchased)
o
The user manual
Install the equipment in a rack cabinet. A one-unit space is requested. Verify that there is enough
space between other functioning equipment generating high temperatures and that there are no
obstructions in the ventilation. (The functioning is guaranteed in a temperature range from -10 ºC ÷
+55 ºC).
The equipment must be correctly grounded, to guarantee a secure functioning.
Connect to the correct power tension reading the information on the manual or on the label
attached to each equipment, containing the serial number.
Connect the network cable to the plug on the rear of the equipment or connect the battery cable to
the related connector. The last used configuration will be loaded.
Connect the flange(s) on the rear panel (or N connectors, depending on frequencies) of the
equipment to the waveguide/cable for the connection to the branching system and the antenna.
Setup the equipment according to the needs consulting the user manual.
7
User interface.
The user interface consists of a general alarm led and a graphical TFT display with
TOUCH SCREEN
function
(for more comfortable use, a stick is available in a compartment located in the front panel , see 9.1).
According to equipment configuration (Half-duplex transmitter[Tx], Half-duplex receiver [Rx], Full-
duplex[FD]), just the related menu are shown.
In order to have a read/write privilege and thus modify the configuration of the equipment, it’s required
the connection of a USB pen with the right token to the USB port in the front panel; on the other end, it’s
required to digit a numeric password while trying to modify one parameter (the password is tied to the
customer’s name and it’s notified at delivery).