7
oven features may vary.
Fitting the side racks and catalytic panels
(some models only, purchased separately)
You will find your side racks and catalytic panels
(some models only, may be purchased separately)
in the accessory box supplied with your oven.
Fit the catalytic panel to the side rack
1
Ensure the panels are placed the correct way around:
the hole for the fixing screw goes to the front of the oven.
(Note: The panel should sit flush against the oven wall).
2
Fit the rear prongs of the side rack through the
holes in the catalytic panel.
Fit the side racks
1
Slide the rear prongs of the side rack into the holes at
the rear of the oven
2
Fit the side rack front tab (and catalytic panel if fitted)
over the fixing screw.
3
Replace the fixing nut. You may use a coin to tighten the nut.
Fixing nut
Side rack
Rear prongs
Catalytic panel
(if fitted)
INTRODUCTION
Summary of Contents for OB60SC SERIES
Page 1: ...Built in oven OB60SC single models NZ AU USER GUIDE...
Page 2: ......
Page 50: ......
Page 51: ......
