5
Remove transport packaging
The appliance and the interior fittings are protected for transportation. Pull off the adhesive tape
on the left and right side of the door. You can remove any remnants of adhesive using white spirit.
Remove all adhesive tape and packing pieces from the interior of the appliance.
Installation Instructions
Installation Location
Before installing, carefully read the instruction in order to avoid a certain number of problems.
Positioning
Position the appliance away from sources of heat such as stoves, radiators, direct sunlight etc.
Maximum performance and safety are guaranteed by maintaining the correct indoor temperature
for the class of unit concerned, as specified on the rating plate. The appliance may not work
properly if it is left for a longer period at a temperature above or below the indicated range.
IMPORTANT!
-There is a need of good ventilation around the fridge for easy dissipation of heat,
high efficiency of freezer and low power consumption. For this purpose, sufficient clear
space should be available around the freezer. It is advisable for there to be 75mm separating
the back of the freezer to the wall, at least 100mm of space at its two sides, height of over 100mm
from its top and a clear space upfront to allow the doors to open 160
°
.
Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the lower
rear section of appliances, as poor air circulation can affect performance. Built-in appliances
should be positioned away from heat sources such as heaters and direct sunlight.
Under no circumstance should you attempt to repair the appliance yourself.Repairs carried out by
inexperienced persons may cause injury or serious malfunctioning.Contact your local service center.
Climate class
Ambient temperature
SN
to
10
C
+
32
C
+
N
ST
T
to
16
C
+
32
C
+
to
16
C
+
38
C
+
to
16
C
+
43
C
+
Leveling
The appliance should be level in order to eliminate rocking. To make the appliance level, it should