Elba ES60-310 XD, Instructions For The Use

Page: 34 / 72

34
CLEANING ELECTRIC HOTPLATES
(models with electric hotplate)
Foods burned on the hot plates must
always be cleaned dry.
Do not use water to avoid the forming of
rust.
After its use, pour a bit of oil onto the warm
plate and rub with a cloth.
CONTROL KNOBS
The control knobs may be removed for
cleaning but care should be taken not to
damage the seal.
GAS TAPS
• Do not let cleaning products come into
contact with the valves.
• Periodic lubrication of the gas taps
must be carried out by specialist
personnel only.
• In the event of operating faults in the
gas taps, call the Service Department.
BURNERS
These parts must be cleaned using a
sponge and soapy water or other suitable
non-abrasive products. Dry with a soft
cloth.
Warning! Not dishwasher safe.
After cleaning, the burners and their flame
spreaders must be well dried and correctly
replaced.
It is very important to check that the burner
flame spreader and the cap have been
correctly positioned. Failure to do so can
cause serious problems.
Check that the probe “
T ” (figs. 3.1, 3.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Check that the electrode “
S ” ( figs. 3.1,
3.3) next to each burner is always clean to
ensure trouble-free sparking.
Both the probe and ignition plug must
be very carefully cleaned.
The electrode “S” must be very carefully
cleaned. To avoid damage to the electric
ignition do not use it when the burners
are not in place.
CORRECT REPLACEMENT OF
THE AUXILIARY, SEMIRAPID AND
RAPID BURNERS
It is very important to check that the burner
flame distributor “ F ” and the cap “ C ” has
been correctly positioned (see figs. 3.1 -
3.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see fig. 3.5); the burner rib
must be enter in their logement as shown
by the arrow (see fig. 3.3).
The burner correctly positioned must not
rotate (fig. 3.4).
Then position the cap “
A
” and the ring “
B
”
(figs. 3.4 - 3.5).
Note: Continuous use may cause a
change in the glaze around the burners
and grids, corresponding to the areas
exposed to the heat. This is a natural
phenomenon and does not prevent the
parts from working properly.